Why is the spark too weak or unable to ignite? Are you also troubled by this problem, please follow our steps to repair your forklift.

Reason 1: Ignition coil is damaged

Troubleshooting method: Replacing the ignition coil

Troubleshooting method: Adjust the gap or remove oxides on the electrocution

Troubleshooting method: Replacing the capacitor

Troubleshooting method: Replacing high voltage wires or fastening heads

Troubleshooting method: Replace or tighten low voltage wires

Reason 6: The ignition coil or distributor is wet
Troubleshooting method: Remove and dry, but not too close to the fire

Reason 7: Spark plug insulator rupture
Troubleshooting method: Replacing spark plugs

Reason 8: The spark plug is wet or carbon deposits on the electrode
Troubleshooting method: drying or removing carbon deposits

Reason 9: Spark plug electrode gap is too large or too small
Troubleshooting method: Adjust the gap

Reason 10: Insufficient battery power
Troubleshooting method: Dismantle charging

Reason 11: Broken distributor cover or distributor connector
Troubleshooting method: replace

Reason 12: Ignition timing is wrong
Troubleshooting method: Check firing sequence

Reason 13: Water in the cylinder head
Troubleshooting method: Remove the cylinder head to remove the accumulated water, and tighten the cylinder head nut as required. If the cylinder head liner is damaged, it should be replaced