Whether your forklift is also underpowered, please follow this article to check your forklift. If you find that you need to replace parts, please do not forget to contact Yuansong Trading.

Reason 1: Ignition too late or too early

Troubleshooting method: Adjust the ignition angle of the distributor

Reason 2: The spark from the spark plug is too weak

Troubleshooting method: See "Difficulty starting the engine" in this series of articles

Reason 3: Bad cylinder compression

Troubleshooting method: See the corresponding fault analysis and troubleshooting in "Difficulty in starting the engine" in this series of articles

Reason 4: Engine overheating

Troubleshooting method: See "Engine Overheating" Troubleshooting and Troubleshooting in this series of articles

Reason 5: Poor gasoline supply

Troubleshooting method: See the corresponding fault analysis and troubleshooting in "The engine runs abnormally or stops halfway" in this series of articles

Reason 6: Fuel specification mismatch

Troubleshooting method: switch to gasoline with the same specification

Reason 7: Excessive spark plug gap

Troubleshooting method: Adjustment

Reason 8: Partially closed choke or insufficient throttle opening

Troubleshooting method: Adjusting the manipulation mechanism

Reason 9: Intake manifold leak

Troubleshooting method: Overhauling the intake manifold and gasket

Reason 10: Excessive wear on camshafts and tappets

Troubleshooting method: replace

Reason 11: Clogged Air Filter

Troubleshooting method: cleaning and unclogging